0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
CK 24 Flex Head, gas-cooled 80 amp ACHF or DCSP @ 100% 20.9cm (8.25"), 64gm, 8 series head accessories.
Fitted with CK's Superflex Cable
Lightest most flexible cable assemblies available.
Available for all gas-cooled or water-cooled torches.
Lightweight silicon rubber hose with nylon over braid protection to resist abrasion.
Replaces heavy, stiff cables increasing range of motion.
Stays flexible even in the coldest environments.
Great for intricate precise welding applications.
For parts for this torch, click here.
Answers to common questions about compact, low-profile air-cooled TIG torches for tight-access welding.
A flexible head lets you bend the neck to the angle the joint needs, which helps with tight spaces, awkward overhead joints and work around framework. A rigid head holds one fixed angle, so it is steadier for repeat work where the approach is always the same.Treat a rigid head as rigid: forcing it to bend can break the torch. If you are not sure which suits your joints, think about the tightest corner you regularly weld and whether you need to change angle during the job. Heads and parts are made to fit particular torch styles, so check the data plate and manual before ordering.
Duty cycle describes how long a torch can work at a given current before it needs to cool down. It is usually quoted over a ten-minute period, and it is tied to a particular current, so a torch that copes with a high duty cycle at a lower current may need much more rest at a higher one. A rating of 100% means continuous welding without forced breaks.Air-cooled torches rely on the shielding gas and the surrounding air for cooling, so they suit lighter, shorter or intermittent welding. For long, hot runs at high current a water-cooled torch is usually a better fit. Always check the rating on the torch data plate for the current and polarity (AC or DC) you intend to use.
Often, yes. A standard collet body lets the gas exit through a ring of small holes into the cup, while a gas lens uses fine screens to spread the gas into a smoother, more even column. That better shield is what allows you to extend the tungsten a little further to reach into corners and grooves, and it can often give good coverage with less gas.A gas lens matters most for DC work. For AC welding on aluminium it is less important, and some welders go back to a standard collet body with a smaller cup and slightly more flow. Collet bodies, collets and cups must match your torch style and your tungsten diameter, so use the maker's parts list.
For AC welding of aluminium, zirconiated tungsten is the usual preferred choice. For DC welding of steel and stainless, ceriated or lanthanated tungsten are generally accepted general-purpose electrodes. Pure tungsten also works on AC but wears faster.The tungsten diameter must suit the current you are using and the collet and collet body fitted, and compact torches generally take smaller diameters. If you are unsure, start with the tungsten maker's current chart and the torch manual, and check that the collet body and collet match the tungsten diameter.
